Solid Nose Cone Kit : 20-350 HP
Click To Enlarge

Solid Nose Cone Kit : 20-350 HP

Price: $164.00
  • Item #: 201-500000
* Marked fields are required.
Qty: *

PLEASE NOTE : SOLID NOSE CONE HAS NO WATER PICKUP HOLES, & NO FITTINGS/HOSE!  Just the nose cone and the epoxy!!!

 

The Solid nose cone kits are if you only need to stream line your case, and do not require low water pickups.  This is a popular choice for I/O engines.  No holes/fittings/hoses.  Just the nose cone and epoxy kit.  If you need a recommendation for which style of nose cone is right for you, please give us a call or email.

If you are using a smaller motor or the Mercury Inline gear case, please choose the 'inline' option, it is a shorter unit.  Rule of thumb is any engines 90 hp or smaller need the inline kit.  If you are smaller than 60hp, please call first, as the cone will require modification to work, and you might perfer to send in for factory installation.

 

 

  • Higher speed & proper water pressure
  • Nose cone kit contains all hardware for complete installation
  • Kit comes complete with ALMAG-35 top grade casting, epoxy, hose fittings and instructions.
  • Crescent shaped for superior and handling

Proven Quality
The same superior design as our World Speed Record Holding Big Foot, low water pick-up cones.


High Water Flow Capacity

Allow surface Piercing props (choppers, cleaver style) to be run at maximum height for top speed and all out performance, while maintaining proper cooling to engine.

Shallow Water Access
Travel and fish waters, until now, were unable to be reaches with outboard motors having standard (side water pick-up) gear cases.

Nose cone test by Bass & Walleye Magazine :

Nose Cone Shootout
Test Results and Fact Sheet

SPEED INCREASE OVER 5 MPH ON A 150 H.P. !!!

NOSE CONES TESTED TOP-SPEED M.P.H. MAXIMUM MOTOR-HEIGHT
OBTAINED ABOVE TRANSOM WHILE MAINTAINING 10 PSI WATER PRESSURE MINIMUM
R.P.M. OBTAINED WITHOUT PROP SLIPPAGE
BOB'S 74.8 Sky High 6250
HYDRO MOTIVE 72.5 3-1/2 inches 6150
LAND & SEA 70.1 2-1/4 inches 5850
MERCURY STOCK 69.7 2-1/2 inches 5900
MERCURY CLS (RACING) 68.5 No limit 6150
       

REMEMBER: THE TRUTH IS AN UNDENIABLE FACT.

Test performed and documented by the Technical Department of an unbiased
major boating magazine, Bass & Walleye Boats, fall issue
NOSECONE SHOOTOUT.

TEST BOAT and EQUIPMENT USED

BOAT:
Nitro 190 TF (19 ft. bass boat)


MOTOR:
Mercury 150XRI 150 horsepower

GEARCASE:
1.87:1 ratio

LOAD:
Two 200 pound men; 28 gallons of fuel, near full livewell (half full)

PROP:
Quicksilver trophy, four blade, small-hub, 13 3/8 x 25 inch pitch

SPEED:

Radar checked (Stalker Radar Gun)


CONDITIONS:
Test held in under four hours with conditions at the start virtually the same as at the end. Flat to 2 inch chop, no wind, with 58 degree's Fahrenheit air temperature.


Reviews (0) Write a Review
No Reviews. Write a Review