The Bravo drive nose cone kit is helpful to stream line your case. It will also increase steering response. Complete kit with nose cone, epoxy and instructions. This is for 1990 and newer Bravo 1 gear cases.
- Higher speed & proper water pressure
- Nose cone kit contains all hardware for complete installation
- Kit comes complete with ALMAG-35 top grade casting, epoxy, hose fittings and instructions.
- Crescent shaped for superior and handling
The same superior design as our World Speed Record Holding Big Foot, low water pick-up cones.
High Water Flow Capacity
Allow surface Piercing props (choppers, cleaver style) to be run at maximum height for top speed and all out performance, while maintaining proper cooling to engine.
Shallow Water Access
Travel and fish waters, until now, were unable to be reaches with outboard motors having standard (side water pick-up) gear cases.
Nose cone test by Bass & Walleye Magazine :
Nose Cone Shootout
Test Results and Fact Sheet
SPEED INCREASE OVER 5 MPH ON A 150 H.P. !!!
|NOSE CONES TESTED||TOP-SPEED M.P.H.||MAXIMUM MOTOR-HEIGHT
OBTAINED ABOVE TRANSOM WHILE MAINTAINING 10 PSI WATER PRESSURE MINIMUM
|R.P.M. OBTAINED WITHOUT PROP SLIPPAGE|
|HYDRO MOTIVE||72.5||3-1/2 inches||6150|
|LAND & SEA||70.1||2-1/4 inches||5850|
|MERCURY STOCK||69.7||2-1/2 inches||5900|
|MERCURY CLS (RACING)||68.5||No limit||6150|
REMEMBER: THE TRUTH IS AN UNDENIABLE FACT.
Test performed and documented by the Technical Department of an unbiased
major boating magazine, Bass & Walleye Boats, fall issue NOSECONE SHOOTOUT.
TEST BOAT and EQUIPMENT USED
Nitro 190 TF (19 ft. bass boat)
Mercury 150XRI 150 horsepower
Two 200 pound men; 28 gallons of fuel, near full livewell (half full)
Quicksilver trophy, four blade, small-hub, 13 3/8 x 25 inch pitch
Radar checked (Stalker Radar Gun)
Test held in under four hours with conditions at the start virtually the same as at the end. Flat to 2 inch chop, no wind, with 58 degree's Fahrenheit air temperature.